ProClip 840651 (only for original apple to USB cable)

This Holder is custom made to fit your iPod. The Holder has grooves in the inside walls matching the thickness of the sides of your iPod. A cable (FM, Charging, Line Out, Stereo Integration etc.) where the cable plug has the same design and size as the original Apple iPod cable plug can be permanently attached to the Holders base. When the cable plug is placed into the base of the Holder, the buttons on each side of the plug are permanently pressed into the plug so you can freely slide the device in and out of the Holder.

The Tilt Swivel on the back of the Holder can tilt 15 degrees in any direction and swivel 360 degrees. The Tilt Swivel provides easy adjustment of your handhelds position for better viewing. You can also adjust the Holder to avoid unnecessary light reflection. (The Holder shown in the picture to the left is attached to a demo ProClip Mount)

The Tilt Swivel Base Plate on the back of the Tilt Swivel can be attached to any flat surface or mounting brackett. The base plate comes with 6 pre-drilled holes; 2 holes in a center line and 4 holes in an almost square like pattern to accommodate the AMPS hole pattern. Enclosed in the packaging are 4 self tapping screws and 4 machine screws with nuts.

• Plush Coated
• Locking feature at the holders base for permanent cable attachment
• For use with all cables (FM, Charging, Line Out, Stereo Integration etc.) where the cable plug has the same design and size as the original Apple iPod cable plug
• Custom fit to your device
• Holds device securely
• Keeps your device within easy reach
• Easily slide device in and out
• Keeps your device upright for better viewing
• Neat and discreet design blends well with vehicle's interior
• Holder can tilt 15 degrees in any direction and swivel 360 degrees
• Made of heat and cold resistant ABS plastic