Panavise 75138-405

This item is no longer available.

Panavise 75138-405

gray starsBe the first one to write a review
2005.5 Jetta Custom Dash Mount
$21.99
This mount gives you a flat mounting location from many different uses. Use it with a holder to mount a satellite radio, navigation system , MP player or cellular phone. Custom dash mounts are vehicle-specific and are carefully engineered and manufactured in the panavise factory. InDash Mounts are ergonomically designed and will not interfere with gauges, vents or air bag deployment.

"

Volkswagen

Jetta 2005.5

 

"

Installation Instructions

Step# 01
With hook tool remove the upper air vent grill. Start by inserting the hook tool into the back corner of the grill, lift to release (2) plastic clips. Continue to release (8) more plastic clips. Disconnect the plug, set bezel aside. With T-20 torx driver remove the (1) exposed screw at the front of the vent shroud. Pull up on the back to release (2) spring clips. Tilt up the shroud and pull it towards the windshield to clear (2) 1/2"" long tabs. Set shroud aside.

Step# 02
With hook tool assist pull the bezel that surrounds the air vent shroud from the back to release (3) plastic clips. Insert hook tool into the sides of the bezel to release (2) soft clips. This will allow the air vents to move. The air vents need to tilt up from the back side by the air vents to release (2) plastic clips that vertically separate the air vent bezel from the radio and climate control bezel. You will need to carefully pry up the air vent bezel at the upper side of the radio corners with a flat screwdriver. Release the air vent bezel assembly and set it aside.

Step# 03
With T-20 Torx driver, remove the (2) screws that hold the radio and climate control bezel in place. Carefully remove the bezel around the radio and climate control. There are (8) small thin metal clips that hold it in place. Set bezel aside. With T-20 Torx, remove the (4) screws that hold the climate controls in place, and set climate control out of the way. Remove the (1) lower radio mounting screw, and the (1) screw that is directly below the right corner of the radio.

Step# 04
Place the InDash"

"

Share on FacebookBookmark and Share