This part holds a standard radio in place and fills the gaps around the radio for a factory finish. It is painted to match the factory dashboard.
This harness connects to the factory wiring behind the radio and under the glove box.
This wire translates your factory steering wheel controls for use with your new radio when used with the harness above.
Converts the connector on harness 2 into a connection specific to your radio.
Use the list below to figure out which one you need.
This cable connects to the AM/FM antenna on the drivers side of the car next to the rear seat.
Reverse camera that replaces your factory trunk/hatch release handle.
This harness give you power for this or any camera from the wiring harness behind the radio. It connects to the main harness above. Without this you must connect to the cars wiring.
If you are bypassing the CD Changer you will need one of these for bypass the fiber lines.
These tools come in handy when removing the cars interior trim.
Sale!
